Detectors, Decoders & Special FX Devices

These detectors are for our ADiA range of accessory decoders and have been designed to be very easy to install. Super-slim at only 4mm in diameter, they will fit comfortably between the sleepers of DCCconcepts and Peco Code 100 and Code 75 track as well as most other brands of track in HO. (N scale users will need to temporarily move a sleeper while drilling, but will also find installation quite easy).

They are “Normally Off” and are triggered or turned on by a locomotive or rolling stock with a reflector fitted.

DCCconcepts Infra-Red Detectors are tested for use in all lighting conditions and at all locomotive speeds to ensure reliable operation. The connector is supplied so that the detectors can be used with our ADiA range of Accessory Decoders.

Physical Characteristics

• Length of sensor: 23mm
• Width of sensor: 4mm
• Length of wire: 150mm
• Quantity in pack: 3

Accessories and Essentials
Cobalt ADiA Intelligent 3-Address Accessory Decoder
Infra-Red Reflectors
Magnetic Sensors
Sensor Magnets
Instructions: General Information
Instructions: Setting Addresses
Instructions: Sensor Controlled Turnout Control
Instructions: Automatic Reverse Loop
Instructions: Scissors Crossover Installation
Instructions: Three-Way Turnout Installation